6 Tack Weld Clamp Set - Pipe, Tube - Full Range 1 1/4" to 5"

Description

Universal Pipe Tube Welding Tack Clamp Set
Made in New York
Design by
Rob
This will show people you're a better welder, because you use the right tools, for quality weld.
Show off your nice welds, with tight and accurate seams.
Simple but affective
Six clamps
can be used on any pipe size
ranging from 1 1/4" inch to 5" inch diameter pipe
Simple two steps:
Attach two chain clamps and tighten thumb nuts.
Then tighten three side thumb nuts to clamp and align seam.
More sizes in other auctions
One customers comment:
one important thing you might mention in your ad: when tig welding two tubes together you need an earth clamp to both parts (best), when parts are not touching each other, the arch jumps to the half where the clamp is connected to and it might cause a melting of the rim. Your clamp gives the earth good to both halves, which prevents that problem.
Assembly is required. Chain is greased to prevent rust until it reaches customer. Degreasing is required.
Testimonial:
Hi Rob,
I am an engineer working on AH-1W helicopter. My welders used this clamp to facilitate a repair on the heat exchanger for the Environmental Control Unit.Worked great!